a Taco rear plate bumper.

Before;


After;

Some stuff on my own junk.

Got tired of smashin tail lights so.

Before;



After;



I like the look of the stock sides better but I gained 2-5" of clearance at the corners.

Also built a tie-rod/assist ram guard on the front housing so I don't smash the ram on any of the tall curbs at the mall.....Pics coming soon.

Nice work.

As promised here's some pics;

Well as some of you know or figured out. I got a new day job, I started today. It will be nice to have a consistant paycheck again.

I am keeping the shop open on a partime basis. My schedule will allow me to work there in the evenings and on the weekends. The shop has been so slow over the last 2 months it is only a part itme job anyway.

The new job is a engineering position for a aerospace repair facility at Scottsdale Airpark. Commute is about the same as when I was at Honeywell. It is however quite the pay cut but its still better than what I made over the last 5 months in the shop......

Thanks to all of you who have helped me out over this time frame and I hope to help you out in the future as well.

For the next few months I am going to concentrating on learing this new job, setting up a schedule, working in the shop when needed and building my bank account back to what it once was. I will not be making hardly any "trips" unless its to the cabin for a break on a normal weekend......

Congrats on the new job

Congrats, Sy. Certainly an answer to prayer, and I appreicate your attitude towards having work, even though its a pay cut. I'm truly happy for you. :clap:

Good news on both fronts. Hopefully the new job goes well and I'm glad you are able to keep the 4wd Headquarters shop open on the side!